A linear guide rail lubricants added:

Laser engraving machine used for a period of time, carving, cutting the smoke, dust, corrosive effect on the rail there, there was a need regular maintenance guide.

Laser engraving machine will shut down power, with a clean soft cloth to clean rail, and then drop on the rail lubricating oil, finished oil on the slider to enable scrolling back and forth in the Guide to make sure the slider to enter the internal lubricant. End of oil on the slider so that you scroll back and forth in the Guide, this time to be loaded onto rail at first, pay attention to when rail equipment will not be fixed, fixed-screw fitted to maintain the level of the belt and slip in fixed block, and then installed lens, dimming the way you finished X direction.

Second, mirror | mirror polished Highlights:

Laser engraving machine | laser cutting machine used for a period of time, the smoke of dust will adhere to the surface of the lens, the impact of carving, cutting depth, will also affect the carving, cutting accuracy. General in a week or so (based on laser cutting machine | engraving machine frequency) will be using ethanol three mirrors, a focusing mirror clean carefully.

Third, bearing oil:

Laser cutting machine using a large number of bearings, in order to ensure a good cutting, carving effect, some bearings require regular refueling (except oil bearing), with a clean soft cloth to wipe surface dust on the bearings with a needle to needle oil inhalation, and then needle slowly into the bearings, rotating slowly in the oil bearing when you can.

Fourth, timing belt (belt) elastic adjustments:

Laser cutting machine drive system in a number of articles in the timing belt, if the timing belt too loose, there will be ghost appears carved font, and if too tight timing belt, timing belt will cause wear and tear. In the use of a period of time, please adjust the timing belt tension screws will be adjusted to the elastic belt fit, the text does not appear carved ghosting, and laser engraving machines, laser cutting machine is running very low noise better, or the manufacturers of the technology consulting staff.

Laser engraving machine laser cooling is the use of recycled water, long-term use of them, there will be some white tube of the scale, we can add a small amount of recycled water vinegar will get rid of drain pipe and then clean laser tube of water washed away the internal cycle, so that laser will be in the best working condition, life expectancy will be extended.