|
 |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| · |
metal mould,rolling samples |
|
| · |
metal mould,rolling samples |
|
| · |
YAG laser marking samples |
|
| · |
paper,glass,plastic |
|
| · |
textile,leather,cloth |
|
| · |
stone,wood,metal |
|
| · |
rubber,plywood,photo |
|
|
 |
 |
|
|
Tel: |
0086-531-66982237 88692337 |
|
Fax: |
0086-531-88692337 |
|
Email: |
master@morntech.com
sales@morntech.com |
MornTech-USA |
|
Add:7475 Murray Dr # 8 |
|
Stockton:CA 95210,USA |
|
Phone #:(209)271-9818 |
|
Email:USAsales@morntech.com
USAinfo@morntech.com |
|
|
|
|
| Laser engraving machine works |
Dot matrix dot matrix engraving sculpture resembles a high-resolution dot matrix printer. Laser head from side to side, each carving out a series of points formed by the line, and then the laser moves up and down while carving out a number of lines, and finally full-page image or text. Scan graphics, text and vector graphics using the lattice can be carved. Vector cutting and engraving different lattice, vector cutting is the outer contour line in the graphics were. We usually use this model in wood, acrylic, paper and other materials to penetrate the cut surface can also be carried out in a variety of marking operations. Engraving speed: engraving speed refers to the speed of laser head movement, usually IPS (inches / sec) that bring high-speed productivity. Speed is also used to control the cutting depth, for a particular laser intensity, the slower the speed, depth of cutting or carving the greater. You can adjust the speed using engraving machine panels can also be used to adjust the computer's operating software. 1% to 100% of the range of adjustment is 1%. Hummer machine advanced motion control system can make your high-speed carving, still get the quality of ultra-fine engraving. Engraving strength: strength that shines on the carving surface laser intensity. Rate for a particular sculpture, the greater the intensity, depth of cutting or carving the greater. You can adjust intensity of use of engraving machine panels can also be used to adjust the computer's operating software. 1% to 100% of the range of adjustment is 1%. The greater the intensity, the smaller the equivalent speed. Depth of cut deeper. Spot size: laser beam spot size can be used to adjust the lens of different focal lengths. Small spot of the lens for high resolution engraving. Great spot for the low-resolution lens engraving, but for vector cutting, it is the best option. The new equipment standard is 2.0 inch lens. The spot size in the middle for various occasions. Laser marking materials: wood, glass, metal, glass, stone, quartz, Corian, paper, color plates, aluminum, leather, resin, spray metal. |
|
|
|
|
|
