Laser Engraving And Cutting Machine & CNC Router Machine Solution
Home About usNewsThe daily maintenance for CO2 laser cutting machine ( I )

The daily maintenance for CO2 laser cutting machine ( I )

Time:Dec 24, 2015Author:Cherry

The stability of the machine to work properly, and the usual proper operation and maintenance are inseparable. The following Morn will introduce the daily maintenance of co2 laser cutting machine to you:

 

1. The change of water and water tank cleaning (recommended clean water tank and replace circulating water once a week)

 

Note: the machine work before must ensure that the laser tube is full of circulating water.
Circulating water quality and water temperature directly affects the service life of laser tube, it is recommended to use pure water, and to control the water temperature below 35 ℃. For more than 35 ℃ to replace the circulating water, or to add ice to reduce the water temperature, water (cooling machine, suggest the user to select or use two tank).
Clean water tank: first, turn the power off and remove water inlet pipe, let the laser tube of water into the tank automatically, open the water tank, pump and clear the dirt on the water pump. Good clean water tank clean, replace the circulating water, the water pump to restore back into the water tank, the connection pipe inserted into the inlet of the pump, tidy up the joint. The pump power alone, and run 2 to 3 minutes (the laser tube is full of circulating water).

 

2. The cleanness of the fan
Fan for a long time use, can make the fan inside the accumulation of a lot of solid dust, let the fan make a big noise, in addition to flavor and is unfavorable to the exhaust. When appear insufficient suction fan smoke not free, turn off the power supply first, will be discharged into the duct and the duct on the fan, remove the inside of the dust, and then put the fan on, and pull out the inside of the blades, until clean, then put the fan installed. Then it can support the co2 laser machine well working. 

 

3. The lens cleaning (advice before work every day, clean equipment was turned off)
Machine is introduced in front, has talked about carving machine has three pieces of reflector and 1 piece of focusing mirror (1 reflector in the laser tube, the launch of the exit is at the upper left of the machine, the reflector is in the left side of the beam's # 2 and # 3 mirrors in laser head on top of the fixed part, is located in the lower part of the laser focusing mirror adjustable lens barrel), after focusing laser is through the lens reflex, emitted from a laser. Lenses can easily touch dirt or other contaminants, cause loss or damage of lens of laser, no. 1 and no. 2 don't must be removed, while the lens cleaning need to dip in a cleaning fluid to clean lens paper carefully wipe up along one edge of the lens central to rotary. No. 3, lens and focus lens from the frame, in the same way to wipe, wipe after the completion of the same back then.

 

Note: (1) The lens should be wiped gently, do not damage the surface coating;
(2) Should take put down gently wipe process, prevent fall;
(3) Focus lens installation please be sure to keep the concave downward.

 

For the second part daily maintenance for co2 laser cutting machine, please check the news published on December 30th, 2015. Or if you have other questions or want to buy one co2 laser engraving and cutting machine, please feel free to contact me. Thank you.


  1. Previous:Word Cup crafts laser making machine
  2. Next:co2 laser cutter and paper cut

FREESAMPLES

FREESOLUTIONS

© 2016 Morn Technology. All Rights Reserved.Privacy PolicyTerms Of UseSitemapSitemap