Laser Engraving And Cutting Machine & CNC Router Machine Solution
Home About usNewscommon problems for laser cutting engraving system

common problems for laser cutting engraving system

Time:Dec 18, 2014Author:Amy

 

 

If the Boot but laser cutting machine is not start    
1.Check whether the machine electricity is ok
2.check the  main parameters  is correct  
Method:
1.check the electrical wires again
2.set up the parameters refer by software instructions

 

If Working without laser 
1.Check wether the optical path skewing
2.Line problem 
Method :
1.Adjust the  light path
2.Judgment with plug the rays into the power of the signal terminal

 

The laser on and off at work    
1.Check whether the water cycle is ok 
2.whether the supply voltage is stabilize  
Method :                                                            
1.Clean the water tank and water pump,clear the pipe
2.Add voltage stabilize to power supply 

 

 

Theonline data can’t be disposed    
1.whether the communication cable is connected 
2.whether the
 software USB is  installed
Method 
:    
1.Shutdown and reconnect the cable
2.Reinstall the software and USB drive

 

 

Processing size does not  consistent with software set 

1.Install the software
2.Adjust action    
Method:
1.install the original software torecover original parameters
2.sized the working area and trim size .calculate refer to software 

 

 

The control panel  no light 
1.Line is loose
Check whether the connecting line is loose  from main board to panel 
If Boot reset is limited    
There is  problem of limit switch and signal   
Check parameter of software and limit switch setting 
If Carving dislocation
1Electrostatic interference
2Drive parts is loose
Method:
1.Reconnect ground wire two meters below ground
2.Check if the gear top silk and strap is loose

 


  1. Previous:Word Cup crafts laser making machine
  2. Next:Upgrade small laser engraving cutting machine

FREESAMPLES

FREESOLUTIONS

© 2016 Morn Technology. All Rights Reserved.Privacy PolicyTerms Of UseSitemapSitemap